In development

Cut Card is being built now. It is not available yet.

Cut Card

Pipefitting calculator

Know the cut before the torch comes out.

Cut Card gives pipefitters, pipe welders and steamfitters the number they actually cut. Enter the center-to-center and it takes off both fitting takeouts and the root gap at each weld, then rounds the answer to a mark you can make with soapstone. The working stays on screen, so you can check every step before you cut.

  • Android phones
  • Works with no signal
  1. A cut card for one pipe run A length of pipe between two 90-degree elbows. The center-to-center is 48 inches. Each elbow takes off 3 inches and each weld leaves a one-eighth-inch root gap, so the pipe is cut at 41 and three-quarter inches. The card below lists center to center 48 inches, takeout minus 3 inches twice, root gap minus one-eighth inch twice, and the cut, 41 and three-quarter inches. cut 41¾″ 3″ 3″ 48″ center to center Center to center48″ Takeout, 2″ 90° ell−3″ ×2 Root gap−⅛″ ×2 Cut 41¾″
    Illustration · example numbers, not to scale

    The cut, not just the math

    Center-to-center minus both takeouts, minus the root gap per weld, rounded to a mark you can make. Every takeout and gap stays on the card, so a wrong number gets caught on the screen, not on the pipe.

Also planned

  • Check backwardsEnter a cut you measured or already made and see the center-to-center it gives, before the torch comes out
  • Offsets solvedSimple and rolling offsets, and travel, run and set at the standard fitting angles, with the formula shown
  • A tape that never forgetsEvery solve is kept, so you can star a line or bring it back with a tap
  • A cut list for the foremanSend the job's cut list as plain text, with a diameter-inch total
  • A weld log that clones the last jointOne button repeats the last weld and bumps the number, and it warns before a process's continuity lapses
  • Built for gloves and basementsBig tiles, no signal needed, and it reopens exactly where you left it